DGIndex Log File - No Field Order

Danette · Post by **Danette** » Tue May 04, 2021 10:01 am

When “Enable Info Log” is selected, the resulting log file does not contain the Field Order that was detected during the preview. Can this be fixed?

I also notice that there are other categories of info that are missing results, such as FPS.

Post by **Rocky** » Tue May 04, 2021 12:11 pm

Thank you, Danette, I'll look into it.

Post by **Rocky** » Tue May 04, 2021 1:51 pm

I understand you are using DGIndex through DGIndex Batcher. Does it use CLI mode or does it open DGIndex normally? If it uses CLI, try giving the -preview option on the CLI invocation.

Danette · Post by **Danette** » Tue May 04, 2021 3:09 pm

Yes, it is through DGIndex Batcher, but it also doesn't report these results when used by itself with the "Preview" function, i.e.; it seems that this log is not a part of DGIndex Batcher, other than DGIndex Batcher calling it from DGIndex. I don't know how to determine if CLI mode is being used by DGIndex Batcher or DGIndex, without asking StainlessS. However, when I watch the DGIndex Batcher process, the windows that I see invoked, are the same as when I run DGIndex by itself.

Let me know if you wish me to ask StainlessS.

Post by **Rocky** » Tue May 04, 2021 5:29 pm

Thank you. I already asked him over at Doom9.

Post by **Rocky** » Wed May 05, 2021 11:20 am

It does not use CLI so the -preview option is inapplicable. StainlessS has given you a solution implemented in DGIndex Batcher so I do not plan to modify anything in DGIndex.

Danette · Post by **Danette** » Wed May 05, 2021 4:51 pm

Thanks for considering it. I was hoping to be able to use DGIndex, as a standalone, to create a complete log when using the Preview function whenever I didn't need batch processing, but I guess it's not to be. I'll have to check back on that thread to see what solution it is that has supposedly been provided. I must be missing something there.

Post by **Rocky** » Wed May 05, 2021 7:47 pm

Danette wrote: ↑
Wed May 05, 2021 4:51 pm
Thanks for considering it. I was hoping to be able to use DGIndex, as a standalone, to create a complete log when using the Preview function whenever I didn't need batch processing, but I guess it's not to be.

If you are not batching then simply do a preview in DGIndex. Upon close, the log file will be populated as you want.